To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Belt Idler Pulley Replacement

Removal Procedure

  1. Remove the drive belt. Refer to Generator, Air Conditioning Compressor, and Power Steering Pump Belt Replacement .
  2. Lower the vehicle at full height. Refer to Lifting and Jacking the Vehicle .

  3. 2027079
  4. Remove the drive belt idler pulley bolt (2).
  5. Remove drive belt idler pulley (1).

Installation Procedure


    2027079
  1. Install the drive belt idler pulley (1).
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the drive belt idler pulley bolt and tighten to  52 N·m (38 lb ft).
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Install the drive belt. Refer to Generator, Air Conditioning Compressor, and Power Steering Pump Belt Replacement .
   


© Copyright Chevrolet. All rights reserved