Cruze

Timing Belt Inspection - Inspection

Special Tools

EN-852 Locking Tool

For equivalent regional tools, Refer to Special Tools .

1. Remove the timing belt upper front cover, Refer to Timing Belt Upper Front Cover Removal .




Note: Turn the engine in the direction of engine rotation. The crankshaft pulley mark and the timing belt rear cover mark must align (1).

2. Set the engine to TDC.



3. The camshaft gear marks must align in opposite to each other (1).
4. Install the EN-852 locking tool .
5. If the marks do not align, then Refer to Timing Belt Inspection .

Install the timing belt upper front cover. Refer to Timing Belt Upper Front Cover Installation .