Cruze

Engine Flywheel Replacement - 1.4L LUH and LUJ

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Open bonnet.
2. Remove clutch pressure and driven plate from engine flywheel. Refer to Clutch Pressure and Driven Plate Replacement .



3. Install EN-652 flywheel holder (1) in order to fix the engine flywheel (2).



4. Remove and DISCARD the 6 engine flywheel bolts (2).
5. Remove the engine flywheel (1).

1. Clean the 6 screw bores. Rework if necessary.



2. Install the engine flywheel (1).
3. Install 6 NEW engine flywheel bolts (2).



4. Install EN-652 flywheel holder (1) in order to fix the engine flywheel (2).

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

5. Tighten the 6 engine flywheel bolts in a cross sequence to 60 N·m (44 lb ft).
6. Tighten the 6 engine flywheel bolts in a cross sequence to an additional 45°. Use EN-470-B wrench .
7. Tighten the 6 engine flywheel bolts in a cross sequence to an additional 15°. Use EN-470-B wrench .
8. Install clutch pressure and driven plate. Refer to Clutch Pressure and Driven Plate Replacement .
9. Install transmission. Refer to Clutch Pressure and Driven Plate Replacement .
10. Close the bonnet.