Orlando

Water Pump and Balance Shaft Chain Tensioner Replacement

1. Remove the engine front cover. Refer to Engine Front Cover Replacement .



2. Remove the 2 tensioner bolts (2) and the water pump and balance shaft chain tensioner (1).

1. Reset the water pump and balance shaft chain tensioner by performing the following steps:

1.1.	Turn the tensioner plunger 90 degrees in its bore and compress the plunger.

1.2.	Turn the tensioner back to the original 12 o'clock position and insert a paper pin through the hole in the plunger body and into the hole in the tensioner plunger.

2. Clean the water pump and balance shaft chain tensioner sealing surface.



3. Install the water pump and balance shaft chain tensioner (1).

Caution: Refer to Fastener Caution in the Preface section.

4. Install the 2 water pump and balance shaft chain tensioner bolts (2) and tighten the bolts to 10 N·m (89 lb in).



5. Remove the paper pin (1) from the tensioner (2).
6. Install the engine front cover. Refer to Engine Front Cover Replacement .