To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Steering Column Lock Control Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

Steering Column Lock Control Module Replacement

If the steering column lock control module needs to be replaced, the following procedures must be performed:

  1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
  2. Perform the SPS function Steering Column Lock Control Module - Programming and follow the on-screen instructions.
  3. Perform the SPS function Steering Column Lock Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both ECU Configuration/Reconfiguration and ECU Setup.
  4. Clear DTCs after completing the programming procedure.

Steering Column Lock Control Module Reprogramming

If the steering column lock control module needs to be reprogrammed, the following procedures must be performed:

  1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
  2. Perform the SPS function Steering Column Lock Control Module - Programming and follow the on-screen instructions.
  3. Clear DTCs after completing the programming procedure.
   


© Copyright Chevrolet. All rights reserved