To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Side Door Window Adjustment

Causes of Slow Moving Window


    443897

    Warning: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

    Note: Owners may comment that the windows operate slowly when going up or down.

  1. Listed below are conditions that may cause a slow moving window.
  2. • The window run channel outboard lip at the rearview mirror is rolled over or the window run channel outboard lip at the rear of door frame (2).
    • The window is not seated in the run channel.
    • The window is misaligned in the opening.
    • The regulator is misaligned causing misalignment of the window.
    • Inspect the power window motor for being loose.
  3. After inspecting the conditions above, do the following:
  4. Remove the front door trim panel.

  5. Remove the water deflector.
  6. Ensure that the window guide is fully seated and clipped.
  7. Ensure that the window is fully seated into the window guide run channel.
  8. Inspect the window for equal distance between the front and rear run channels.

Adjustment Procedure

  1. Inspect for the following conditions before making adjustments.
  2. • Using a flat-bladed tool, straighten the run channel lip by pulling it out to its correct position.
    • Use a flat-bladed tool to push the run channel rearward to seat it in the door frame.
    • Inspect the window guide retainer to window for the proper alignment to the slots in the window.
    • Inspect the window to be straight up and down position.

    1362845
    • Loosen the fasteners that attach the window regulator (1) to the inner door panel, in the specified sequence (2, 3, 4).

    Caution: Refer to Fastener Caution in the Preface section.

  3. Tighten the fasteners that attach the front side door window regulator (1) to the inner door panel in the specified sequence (2, 3, 4) to 11 N·m (97 lb in).
  4. Inspect the window for proper operation.
  5. Install the water deflector.
  6. Install the front door trim panel.
   


&#169© Copyright Chevrolet. All rights reserved