To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Camshaft Position Actuator Solenoid Valve Installation


    2190650

    Caution: The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.

  1. Install the 2 camshaft position actuator solenoid valves (2) and the 2 seal rings (1) by carefully and evenly pressing.
  2. Caution: Refer to Fastener Caution in the Preface section.


    2191735
  3. Install the 4 camshaft position actuator solenoid valve bolts (1) and tighten to 8 N·m (71 lb in).

  4. 2190651
  5. The 2 camshaft position actuator solenoid valves should be installed in the position as shown (1) and (2).
   


© Copyright Chevrolet. All rights reserved