To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transmission Case Cleaning and Inspection

Table 1: Torque Damper and Differential Side
Table 2: Case Side Cover

Torque Damper and Differential Side


2371946

Torque Damper and Differential Side

Callout

Component Name

Caution: Do not use abrasive pads or bristle devices to clean the sealing surfaces. Abrasive pads produce a fine grit that can effect transmission function. Abrasive pads can also remove enough metal to create oil leaks.

Caution: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure.

Caution: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.

Preliminary Procedures

  1. Thoroughly clean the transmission case assembly, including case threads, with clean solvent.
  2. Clean gasket sealing surfaces. Remove all residual gasket material.
  3. Inspect all threaded holes. If necessary, repair any thread damage.

1

Transmission Case Locator Pin

2

Torque Damper and Differential Housing Sealing Surface

3

Generator/Drive Motor Stator Locating Pin

4

Transmission Case Locator Pin

5

Generator/Drive Motor Stator Locator Pin

6

A/Trans Vent Assembly

7

Control Valve Body Cover Sealing Surface

8

Manual Shift Shaft Seal Surface

9

Transmission Fluid Drain Plug

Caution: Refer to Fastener Caution in the Preface section.

Tighten
11 N·m (97.4 lb in)

Case Side Cover


2371948

Case Side Cover

Callout

Component Name

Caution: Do not use abrasive pads or bristle devices to clean the sealing surfaces. Abrasive pads produce a fine grit that can effect transmission function. Abrasive pads can also remove enough metal to create oil leaks.

Caution: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure.

Caution: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.

Preliminary Procedures

  1. Thoroughly clean the transmission case assembly, including case threads, with clean solvent.
  2. Clean gasket sealing surfaces. Remove all residual gasket material.
  3. Inspect all threaded holes. If necessary, repair any thread damage.

1

Transmission Case Locator Pin

2

Generator/Drive Motor Stator Locator Pin

3

Generator/Drive Motor Stator Locator Pin

4

Case Cover Sealing Surface

5

A/Trans Fluid Level Hole Plug (Qty: 1)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
11 N·m (97.4 lb in)

   


© Copyright Chevrolet. All rights reserved