Front Differential Drive Pinion Gear Bearing Cup
Caution: Support the back side of the torque damper housing while installing the bearing cup. Install the bearing cup until it stops moving. Applying excessive pressure to the bearing cup once it is seated could cause damage to the torque Damper housing casting.
Caution: Failure to apply the lubricant will cause damage to the bolt and nut threads.
Procedure
- Tighten DT 49266 until it fits snugly on the bearing cup.
- Adjust DT 45124 so it sits on the torque converter housing surface just beyond the bearing cup opening.
- Apply the extreme pressure lubricant DT 23444-A to the puller bolt threads to prevent damage to the bolt threads during bearing cup removal.
- Hold the puller bridge bolt and turn the nut to remove the bearing cup.
- Use an bearing press with DT-49263 and GE 8092 to install.
Special Tools
| • | DT 45124 Removal Bridge |
| • | DT-49263 Bearing Cup Installer |
| • | DT-49266 Bearing Cup Remover |
| • | DT 23444-A Extreme Press Lubricant - 1/4 Ounce Tube |
For equivalent regional tools, refer to Special Tools .
| 
