To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Torque Damper and Differential Housing Cleaning and Inspection


2371963

Callout

Component Name

Caution: Do not use abrasive pads or bristle devices to clean the sealing surfaces. Abrasive pads produce a fine grit that can effect transmission function. Abrasive pads can also remove enough metal to create oil leaks.

Caution: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure.

Caution: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.

Preliminary Procedures

  1. Thoroughly clean the torque damper and differential housing, including case threads, with clean solvent.
  2. Clean gasket sealing surfaces. Remove all residual gasket material.
  3. Inspect all threaded holes. If necessary, repair any thread damage.

1

A/Trans Fluid Pump Locator Pin

2

Auxiliary Pump Press Plug

Caution: Refer to Fastener Caution in the Preface section.

Tighten
11 N·m (97.4 lb in)

3

Filler Hole Plug

Tighten
20 N·m (14.7 lb ft)

4

Filler Hole Plug Seal

Tip
Discard seal, it is not reusable.

5

A/Trans Fluid Pressure Test Hole Plug

Tighten
11 N·m (97.4 lb in)

6

A/Trans Fluid Level Hole Plug (Qty: 1)

7

A/Trans Fluid Passage Plug

8

Torque Damper and Differential Housing Sealing Surface

9

A/Trans Fluid Level Hole Plug

Tighten
11 N·m (97.4 lb in)

   


© Copyright Chevrolet. All rights reserved