To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Differential Drive Pinion Gear Bearing Cup Removal - Torque Damper Side


2371966

Callout

Component Name

Preliminary Procedure

Do not install the bearing cup until after the selective washer measurement has been performed. Refer to Front Differential Drive Pinion Gear Bearing Thrust Washer and Front Differential Bearing Washer Measurement .

1

Front Differential Drive Pinion Gear Bearing Cup

Caution: Failure to apply the lubricant will cause damage to the bolt and nut threads.

Procedure

  1. Tighten DT 47927-2 until it fits snugly on the bearing cup.
  2. Adjust DT 45124 so it sits on the torque damper housing surface just beyond the bearing cup opening.
  3. Apply the extreme pressure lubricant supplied with DT 23444-A to the puller bolt threads to prevent damage to the bolt threads during bearing cup removal.
  4. Hold the puller bridge bolt and turn the nut to remove the bearing cup.

Special Tools

    • DT 45124 Removal Bridge
    • DT 47927-2 Bearing Cup Remover
    • DT 23444-A Extreme Press Lubricant - 1/4 Ounce Tube

For equivalent regional tools, refer to Special Tools .

2

Front Differential Bearing Washer - Selective

   


&#169© Copyright Chevrolet. All rights reserved