To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Differential Drive Pinion Gear Roller Bearing and Lubricant Dam Removal - Torque Damper Side


2371967

Callout

Component Name

1

Front Differential Drive Pinion Gear Roller Bearing Assembly (Differential Housing)

Caution: Failure to apply the lubricant will cause damage to the bolt and nut threads.

Procedure

  1. Tighten DT 49230-1 until it fits snugly on the bearing.
  2. Adjust so it sits on the torque damper housing surface just beyond the bearing opening.
  3. Apply the extreme pressure lubricant DT 23444-A to the puller bolt threads to prevent damage to the bolt threads during bearing removal.
  4. Hold the puller bridge bolt and turn the nut to remove the bearing.

Special Tools

    • DT 45124 Removal Bridge
    • DT 49230-1 Bearing Remover
    • DT 23444-A Extreme Press Lubricant - 1/4 Ounce Tube

For equivalent regional tools, refer to Special Tools .

2

Front Differential Drive Pinion Gear Lubricant Dam

Procedure

Slide axle seal puller downward to penetrate lubricant dam. Turn counter clockwise to engage threads, then pull with seal puller.

Special Tools

    • DT 48055 Lubricant Dam Remover
    • GE 6125-1B Slide Hammer With Adaptor

For equivalent regional tools, refer to Special Tools .

   


&#169© Copyright Chevrolet. All rights reserved