To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Variable Low and 1-2 Reverse Clutch Housing and Front Differential Transfer Drive Gear Assemble


2371990

Callout

Component Name

Preliminary Procedures

    • Inspect the support assembly for damage or wear to the splines, bushings, machined surfaces and threaded holes.
    • Inspect the transfer drive gear for damage or wear.
    • Inspect the transfer drive gear bearing assembly for proper operation.
    • The bearing should roll smoothly and quietly.

1

Variable Low and 1-2 Reverse Clutch Housing Fluid Passage Seal (Qty: 2)

2

Variable Low and 1-2 Reverse Clutch Housing (O-ring) Seal

Tip
Install a NEW seal. It is not reusable.

3

Variable Low and 1-2 Reverse Clutch Housing Assembly

4

Variable Low and 1-2 Reverse Clutch Housing Bolt M6 x 39.5 mm (Qty: 7)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Rotate centre support clockwise against clutch housing splines before tightening to specified torque.
  2. Tighten the bolts in sequence shown.

Tighten
15 N·m (11 lb ft)

   


&#169© Copyright Chevrolet. All rights reserved