To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Drive Motor Generator Position Sensor Stator Installation


2372000

Callout

Component Name

Preliminary Procedures

    • Inspect the support assembly for damage or wear to the splines, bushings, machined surfaces and threaded holes.
    • Inspect the transfer drive gear for damage or wear.
    • Inspect the transfer drive gear bearing assembly for proper operation.
    • The bearing should roll smoothly and quietly.

1

Locating Pin

2

Generator/Drive Motor Position Sensor Stator Assembly

3

Drive Motor Generator Position Switch Sensor Bolt M5 x 16 mm (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
7.25 N·m (64.2 lb in)

   


&#169© Copyright Chevrolet. All rights reserved