To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Drive Motor Generator Rotor and Stator Installation - Unit B


2372024

Callout

Component Name

1

Drive Motor/Generator Stator Cooling Tube Seal (Qty: 1)

Tip
Install a NEW seal. It is not reusable.

2

Drive Motor/Generator Stator Cooling Tube Assembly (RHS Unit B)

3

Drive Motor/Generator Stator Assembly - Unit B

4

Drive Motor/Generator Stator Cooling Tube Seal (Qty: 1)

Tip
Install a NEW seal. It is not reusable.

5

Drive Motor/Generator Stator Cooling Tube Assembly (LHS Unit B)

6

Drive Motor/Generator Rotor Assembly - Unit B

7

Drive Motor/Generator Rotor Lubricant Seal

Tip
Install a NEW seal. It is not reusable.

8

Drive Motor/Generator Stator Cooling Tube Retainer (Qty: 2)

9

Drive Motor/Generator Rotor and Stator Assembly - Unit B

Warning: The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.

Tip
Insert electrical connector through pass-through hole in case.

Special Tools

DT 50302 Rotor and Stator Lifter Assembly

For equivalent regional tools, refer to Special Tools .

10

Drive Motor/Generator Power Inverter Module Cable Assembly Seal

Tip
Install a NEW seal. It is not reusable.

11

Drive Motor/Generator Power Inverter Module Cable Assembly - 3 Phase - B

12

Drive Motor/Generator Power Inverter Module Cable Stud M6 x 20 mm (Qty: 3) - External

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

13

Auxiliary Pump Motor Cable Retainer - 3 Phase - Cable B/Resolver

14

Drive Motor/Generator Power Inverter Module Cable Housing Cover Seal

Tip
Install a NEW seal, it is not reusable.

15

Drive Motor/Generator Stator Bolt M6 x 20 mm (Qty: 4)

Tighten
9 N·m (80 lb in)

16

Drive Motor/Generator Power Inverter Module Cable Connector Bolt M6 x 20 mm (Qty: 3) - Internal

Tighten
9 N·m (80 lb in)

   


© Copyright Chevrolet. All rights reserved