Preliminary Procedure

Clean and inspect all parts for wear or damage.

1

Centre Support Fluid Passage Plug

2

Drive Motor/Generator Position Sensor Pin

3

Drive Motor Rotor Lubricant Seal Sleeve

4

Drive Motor/Generator Position Sensor Stator Assembly

5

Generator/Drive Motor Position Sensor Switch Bolt M5 x 16 mm (Qty: 4)

Procedure

Tighten the bolts in sequence shown.

Tighten
7.25 N·m (64.2 lb in)

6

A/Trans Control Wiring Harness Shield

7

A/Trans Control Wiring Harness Shield Bolt M6 x 16 mm (Qty: 3) - External

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

8

A/Trans Control Wiring Harness Connector Bracket