1

Generator/Drive Motor Stator Cooling Tube Assembly (RHS) - Unit A

2

Drive Motor/Generator Stator Cooling Tube Seal (Qty: 2)

Tip
Install a NEW seal. It is not reusable.

3

Generator/Drive Motor Rotor Assembly - Unit A

4

Generator/Drive Motor Stator Cooling Tube Assembly (LHS) - Unit A

1

Generator/Drive Motor Rotor and Stator Assembly - Unit A

Warning: The generator motor weighs approximately 23 kg (50 lbs). Personal injury may result if you lift the generator motor improperly.

Tip
Attach the temperature sensor connector.

2

Drive Motor/Generator Stator Bolt M6 x 20 mm (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

3

Drive Motor/Generator Power Inverter Module Cable Housing Cover Seal

Tip
Install a NEW seal, it is not reusable.

4

Drive Motor/Generator Power Inverter Module Cable Assembly - 3 Phase - A

5

Drive Motor/Generator Power Inverter Module Cable Stud M6 x 20 mm (Qty: 3) - External

Tighten
9 N·m (80 lb in)

6

Auxiliary Pump Motor Cable Retainer - 3 Phase - Cable A/3-PH Motor

7

Drive Motor/Generator Power Inverter Module Cable Connector Bolt M6 x 25 mm (Qty: 3) - Internal

Tighten
9 N·m (80 lb in)

8

Drive Motor Power Inverter Module Cable Connector Bolt Seal (Qty: 2)

Tip
Install a NEW seal, it is not reusable.

9

High Voltage Cover to Controller Retaining Bolt