1

A/Trans Fluid Level Control Valve

2

A/Trans Fluid Level Control Valve Stud M6 x 40 mm (Qty: 2)

Caution: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
9 N·m (80 lb in)

3

A/Trans Manual Shift Shaft Position Switch Assembly

Procedure

Push down and turn to unlock.

Tip
Insure the sensor slide is engaged with the pin on the detent lever and place the detent or transmission in Neutral.

4

A/Trans Manual Shift Shaft Position Switch Bolt M6 x 25 mm (Qty: 2)

Caution: Once the manual shift shaft position switch is bolted to specification you must unlock the mechanical locking tab making sure the vehicle and the manual shift shaft position switch are in neutral. The switch may be damaged if not placed in the unlocked position.

Tighten
9 N·m (80 lb in)