To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Stabilizer Shaft Link Replacement


2370998

Callout

Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .

1

Front Stabiliser Shaft Nut (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Using the proper size allen key, hold the stabiliser shaft link ball stud while removing the stabiliser shaft nut.
  2. Remove and discard the nut. DO NOT re-use the nut, replace with NEW only.

Tighten
65 N·m (48 lb ft)

2

Front Stabiliser Shaft Link

Caution: This component is equipped with torque-to-yield fasteners. Install a NEW torque-to-yield fastener when installing this component. Failure to replace the torque-to-yield fastener could cause damage to the vehicle or component.

   


© Copyright Chevrolet. All rights reserved