Callout
| Component Name
|
Preliminary Procedures
- Remove the front bumper fascia. Refer to
Front Bumper Fascia Removal and Installation : Volt → Ampera .
- Remove the windscreen washer container filler tube. Refer to Windscreen Washer Solvent Container Filler Tube Replacement .
- Disconnect the electrical connectors to the washer pump and level sensor.
|
1
| Windscreen Washer Solvent Container Nut (Qty: 4)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 9 N·m (80 lb in) |
2
| Electronic Control Module Bracket
Tip Reposition the electronic control module (ECM) bracket in order to remove the windscreen washer solvent container from the mounting studs. Refer to Engine Control Module Bracket Replacement . |
3
| Windscreen Washer Pump Hose
ProcedureDisconnect the windscreen washer pump hose from the washer pump spout and disengage the washer hose from the side of the windscreen washer solvent container.
|
4
| Windscreen Washer Solvent Container
Procedure
- Remove the container and drain into a suitable clean container.
- Transfer the windscreen washer pump.
- Transfer the level sensor.
- Re-fill the washer container with clean washer solvent once the installation has been completed.
|