To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Shock Absorber Replacement


2370712

Callout

Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
  3. Remove the rear wheel house panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .

1

Rear Shock Absorber Bolt.

Caution: This component is equipped with torque-to-yield fasteners. Install a NEW torque-to-yield fastener when installing this component. Failure to replace the torque-to-yield fastener could cause damage to the vehicle or component.

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Support the rear axle with a suitable jack stand.
  2. Remove and discard the bolt. DO NOT re-use, replace with NEW only.
  3. Support the front end of the vehicle and raise the rear axle to the proper D Height. Refer to Trim Height Inspection .

Tighten

  1. First Pass: 150 N·m (111 lb ft)
  2. Final Pass: additional 65 degrees.

2

Rear Shock Absorber Bolt (Qty:2)

Tighten
100 N·m (74 lb ft)

3

Rear Shock Absorber

4

Rear Shock Absorber Nut

Tighten
20 N·m (15 lb ft)

5

Rear Shock Absorber Upper Mount

6

Rear Shock Absorber Bumper Upper

   


© Copyright Chevrolet. All rights reserved