To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Wheel Stud Replacement


2384894

Callout

Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
  3. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement

1

Wheel Stud (Qty: 5)

Procedure

  1. Rotate the wheel hub to gain enough worker area to remove the wheel stud.
  2. Using the CH 43631 remover, remove and discard the wheel stud from the wheel hub. Replace with new only.
  3. When installing the wheel stud, use the proper amount of washers to allow the wheel stud to be fully seated against the wheel hub flange.
  4. Use a wheel nut with the flat side of the wheel nut facing the washers to fully seat the wheel stud.

Special Tools

CH 43631 Ball Joint Remover

For equivalent regional tools, refer to Special Tools .

   


© Copyright Chevrolet. All rights reserved