To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Outside Wing Mirror Housing Cover Replacement


2374121

Callout

Component Name

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

Preliminary Procedure

Remove the outside wing mirror housing bezel. Refer to Outside Wing Mirror Housing Bezel Replacement .

1

Outside Wing Mirror Housing Cover Retainers (Qty: 3)

Procedure

  1. The housing cover has three molded retainers on the front edge that retains it to the housing.
  2. Lift and slide the housing cover straight forward to release the retainers from the housing.

Note: The housing cover fits in the edge of the turning signal house and it must slid forward to release completely.

2

Outside Wing Mirror Housing Cover

Procedure

  1. Reinstall the housing cover to the housing.
  2. Inner actuator to housing, ensure proper operation.
  3. Position the housing cover to the housing and indicator, push rearward until fully seated.
  4. Place your hand on the back of the mirror housing. Using the flat part of your hand press inward until the mirror glass fully seats to the inner actuator retaining tabs.
  5. Inspect the outside wing mirror for proper operation.
   


© Copyright Chevrolet. All rights reserved