To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Rear Side Door Window Belt Reveal Molding Replacement - Upper


2374107

Callout

Component Name

Preliminary Procedures

  1. Remove the rear side door window garnish molding. Refer to Rear Side Door Window Garnish Molding Replacement .
  2. It will be necessary to remove the lower bright chrome reveal molding to expose the screws, refer to the lower molding. Refer to Rear Side Door Window Belt Reveal Molding Replacement : Lower → Upper .

1

Rear Side Door Window Belt Reveal Molding Frame Screw Covers (Qty: 2)

Procedure

Place the door window in the full down position.

Tip
Two screws are located in the lower corner of the upper door frame under the covers.

2

Rear Side Door Window Belt Reveal Molding Frame Screws (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
2.5 N·m (22 lb in)

3

Rear Side Door Window Belt Reveal Molding Screw (Qty: 5)

Procedure

One screw is located on the back side located in the front corner of the door frame.

Tighten
2.5 N·m (22 lb in)

4

Rear Side Door Window Belt Reveal Molding Push-In Retainers (Qty: 2)

Tip
Lift upward on the molding and sealing strip releasing it from the pinchweld flange.

5

Rear Side Door Window Belt Reveal Molding

Tip
Inspect the window for proper operation before installing the door trim panel.

   


© Copyright Chevrolet. All rights reserved