To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Electronic Brake Control Position Sensor Replacement

Removal Procedure

  1. Remove the driver side inflatable restraint lower module. Refer to Inflatable Restraint Instrument Panel Lower Module Replacement - Driver Side .
  2. Disconnect the electronic brake control position sensor electrical connector.

  3. 2384635
  4. Remove the 2 electronic brake control position sensor bolts (1).

  5. 2384640
  6. Remove the electronic brake control position sensor (1).

Installation Procedure


    2384640

    Note: Ensure the electronic brake control position sensor arm is properly located on the pin of the brake pedal.

  1. Install the electronic brake control position sensor (1).
  2. Caution: Refer to Fastener Caution in the Preface section.


    2384635
  3. Install the 2 electronic brake control position sensor bolts (1) and tighten to 9 N·m (80 lb in).
  4. Connect the electronic brake control position sensor electrical connector.
  5. Install the driver side inflatable restraint lower module. Refer to Inflatable Restraint Instrument Panel Lower Module Replacement - Driver Side .
  6. Inspect the battery state of charge. Refer to Battery Inspection/Test .
  7. If necessary, connect a battery charger to the 12V battery. Refer to Battery Charging .
  8. Install a scan tool to the vehicle.
  9. Note: The power button must remain in the ON position during this procedure.

  10. Place the power button in the ON position.
  11. Using the scan tool, perform the following steps:
  12. 9.1. Select Diagnostics
    9.2. Select the appropriate vehicle information
    9.3. Select Chassis
    9.4. Select Electronic Brake Control Module (EBCM)
    9.5. Select Module Setup
    9.6. Select Electronic Brake Control Position Relearn and follow the instructions on the scan tool
   


© Copyright Chevrolet. All rights reserved