Rear Wheel Speed Sensor Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning in the Preface section.
Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
- Clean the wheel speed sensor mounting area on the suspension knuckle of any accumulated dirt and debris.
- Remove the wheel speed sensor bolt (1).
- Remove the wheel speed sensor (1) from the suspension knuckle.
- Release the wheel speed sensor harness from the rear brake hose retainers (1) and the brake hose bracket (2).
- Remove the lower forward wheelhouse liner pushpin, lift the wheelhouse liner away from the body slightly and disconnect the wheel speed sensor electrical connector (1).
- Release the wheel speed sensor harness retainer (2) from the frame rail and remove the wheel speed sensor.
Installation Procedure
- Install the wheel speed sensor (1) to the suspension knuckle.
Caution: Refer to Fastener Caution in the Preface section.
- Install the wheel speed sensor bolt (1) and tighten to 9 N·m (80 lb in).
- Install the wheel speed sensor harness to the rear brake hose retainers (1) and the brake hose bracket (2).
- Lift the wheelhouse liner away from the body slightly and connect the wheel speed sensor electrical connector (1).
- Install the forward lower wheelhouse liner pushpin.
- Install the wheel speed sensor harness retainer (2) to the frame rail.
- Install the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
- Perform the Diagnostic System Check - Vehicle .
© Copyright Chevrolet. All rights reserved |