Volt

Automatic Transmission Range Selector Lever Replacement

1. Set the park brake and chock the wheels.

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

•	Identify how to disable high voltage.

•	Identify how to test for the presence of high voltage.

•	Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.

Failure to follow the procedures exactly as written may result in serious injury or death.
2. Disable the hybrid high voltage system. Refer to High Voltage Disabling .



3. Disconnect the transmission range selector lever cable terminal (1) from the transmission manual gear shift lever pin.




Warning: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

4. Press the locking tab (1) rearward in order to release the transmission range selector lever cable (2) from the cable bracket.



5. Remove the transmission range selector lever nut (1).
6. Remove the transmission range selector lever (2).

Warning: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.




1. Install the transmission range selector lever (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the transmission range selector lever nut (1) and tighten to 30 N·m (22 lb ft).



3. Install the transmission range selector lever cable (2) to the cable bracket.
4. Press the locking tab (1) forward in order to retain the transmission range selector lever cable (2) to the cable bracket (3).



5. Connect the transmission range selector lever cable terminal (1) to the transmission manual gear shift lever pin.
6. Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment .
7. Enable the hybrid high voltage system. Refer to High Voltage Enabling .