To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Brake System Noise

Step

Action

Yes

No

DEFINITION: Vehicle exhibits abnormal noise when braking; vehicle may exhibit abnormal noise during motion just after brake pedal release.

1

Were you sent here from the Hydraulic Brake Symptom table?

Go to Step 2

Go to Diagnostic Starting Point - Vehicle

2

  1. Inspect the disc brake system for the following conditions.
  2. • Lining wear indicator contact with disc
    • Debris trapped between disc and splash shield or backing plate; and/or debris trapped between disc and linings
    • Contaminated linings
    • Aftermarket linings
    • Glazed linings
    • Distorted, cracked or damaged linings
    • Excessively worn linings
    • Damaged or excessively worn calliper hardware and/or lining hardware
    • Incorrectly installed, loose or missing calliper hardware and/or lining hardware
    • Lack of lubrication or excessive corrosion on metal to metal contact surfaces
    • Bent or damaged splash shield or backing plate
    • Hard spots, heat checks, blueing discolouration of disc friction surfaces
    • Glazed disc friction surfaces
    • Bent or damaged calliper or mounting component
  3. Adjust, repair or replace components as necessary. Refer to Disc Brake System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 3

3

  1. Inspect the brake apply system for the following conditions.
  2. • Lack of lubrication or excessively worn pushrod or pedal pivots or pivot bushes
    • Bent or damaged pedal pushrod, pedal, or pedal bracket
  3. Adjust, repair or replace components as necessary. Refer to Brake Hydraulic and Assist System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 4

4

  1. Inspect the hydraulic brake system for the following conditions.
  2. • Improper operation of calliper pistons
    • Contaminated brake fluid
  3. Adjust, repair or replace components as necessary. Refer to Brake Hydraulic and Assist System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 5

5

Inspect the hand brake system for proper operation. Refer to Hand brake System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Diagnostic Starting Point - Vehicle

6

  1. Install or connect components that were removed or disconnected during diagnosis.
  2. Road test the vehicle in order to confirm proper operation. Refer to Brake System Vehicle Road Test .

Is the condition still present?

Go to Step 2

System OK

   


&#169© Copyright Chevrolet. All rights reserved