To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Brake Pedal Excessive Effort

Step

Action

Yes

No

DEFINITION: Brake pedal requires an increased amount of input from the driver to obtain good braking action and/or stopping distance is increased.

1

Were you sent here from the Hydraulic Brake Symptom table?

Go to Step 2

Go to Diagnostic Starting Point - Vehicle

2

  1. Inspect the brake assist system for the following conditions:
  2. • Lack of lubrication, binding or excessively worn pushrod or pedal pivots or pivot bushes
    • Bent or damaged pedal pushrod, pedal, or pedal bracket
  3. Adjust, repair or replace components as necessary. Refer to Brake Hydraulic and Assist System Diagnosis .

Did you find and correct a condition?

Go to Step 5

Go to Step 3

3

  1. Inspect the hydraulic brake system for the following conditions:
  2. • Binding calliper pistons
    • Internally damaged flexible brake hoses; hindering fluid flow
    • External brake fluid leaks
    • Kinked or damaged flexible brake hoses and/or pipes
    • Internal brake fluid leaks; improperly operating master cylinder
    • Poor brake fluid quality; low boiling point
  3. Adjust, repair or replace components as necessary. Refer to Brake Hydraulic and Assist System Diagnosis .

Did you find and correct a condition?

Go to Step 5

Go to Step 4

4

  1. Inspect the disc brake system for the following conditions:
  2. • Excessively worn linings
    • Glazed linings
    • Cracked, distorted or damaged linings
    • Contaminated linings
    • Binding, damaged or excessively worn calliper hardware and/or lining hardware
    • Lack of lubrication or excessive corrosion on metal to metal contact surfaces
    • Excessively worn or corroded disc friction surfaces
    • Glazed disc friction surfaces
    • Hard spots, heat checks, blueing discolouration of disc friction surfaces
  3. Adjust, repair or replace components as necessary. Refer to Disc Brake System Diagnosis .

Did you find and correct a condition?

Go to Step 5

Go to Diagnostic Starting Point - Vehicle

5

  1. Install or connect components that were removed or disconnected during diagnosis.
  2. Road test the vehicle in order to confirm proper operation. Refer to Brake System Vehicle Road Test .

Is the condition still present?

Go to Step 2

System OK

   


&#169© Copyright Chevrolet. All rights reserved