To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Roof Panel Joint Finish Moulding Replacement


2385216

Callout

Component Name

Preliminary Procedure

    Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

  1. Begin at the rear edge of the roof panel joint finish moulding and carefully pry the moulding from the roof ditch clip.
  2. Pull the moulding forward out of the ditch.
  3. Carefully lift the front edge from the second roof ditch clip.
  4. Clean any adhesive residue from the ditch using a 50 / 50 mixture by volume of isopropyl alcohol and clean drinkable water.
  5. Dry the ditch with a lint free cotton towel.

1

Roof Panel Joint Finish Moulding

Procedure

  1. Insert the front edge of the moulding to the edge of glass.
  2. Using a roller-type tool, roll the moulding into the ditch front to rear to ensure full adhesion is made.
  3. Tuck the rear lip of the finish moulding to the edge of the rear tailgate panel.
  4. Inspect the moulding to roof ditch fit.
   


© Copyright Chevrolet. All rights reserved