To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Rear Side Door Adjustment

Removal Procedure

Up/Down or In/Out Adjustment

  1. Open the door.
  2. Caution : Refer to Paint Damage Caution in the Preface section.

    Note : The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.

  3. Apply masking tape to the wing and the door edges.
  4. Loosen the door side hinge bolts.

    Do not remove the bolts from the door.

  5. Adjust the door up or down by repositioning the door as needed.
  6. Adjust the door in or out by repositioning the door as needed.

Installation Procedure

    Caution : Refer to Fastener Caution in the Preface section.

  1. Install the door side hinge bolts.
  2. Tighten
    Tighten the bolts to 30 N·m (22 lb ft).

  3. Inspect the door for proper operation and alignment.
  4. Remove the masking tape.

Removal Procedure

Fore/Aft Adjustment

    Caution : Refer to Paint Damage Caution in the Preface section.

    Note : The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.

  1. Apply masking tape to the wing and door edges.
  2. Loosen the body side hinge bolts.

    Do not remove the bolts from the door.

  3. Adjust the door fore and aft by repositioning the door as needed.

Installation Procedure

    Caution : Refer to Fastener Caution in the Preface section.

  1. Install the body side hinges bolts.
  2. Tighten
    Tighten the bolts to 30 N·m (22 lb ft).

  3. Inspect the door for proper operation and alignment.
  4. Remove the masking tape.
   


© Copyright Chevrolet. All rights reserved