To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Hand brake Cable Replacement

Removal Procedure

  1. Place the transmission in PARK.
  2. Disable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Disabling .
  3. Place the power button in the OFF position.
  4. Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the left rear tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
  7. Remove the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .

  8. 2391020
  9. Remove the hand brake cable nut (1) from the electronic hand brake control module.

  10. 2391030
  11. Remove the hand brake cable bracket bolt (1).

  12. 2391032
  13. Release the hand brake cable bracket bolt (1) from the vehicle underbody.
  14. Remove the fasteners and position aside the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .

  15. 2391033
  16. Remove the hand brake cable bracket nut (1).

  17. 2391034
  18. Disconnect the hand brake cable equaliser (1) from the left rear hand brake cable.
  19. Disconnect the hand brake cable connector (2) from the right rear hand brake cable.
  20. Remove the hand brake cable from the vehicle.

Installation Procedure

  1. Install the hand brake cable to the vehicle.

  2. 2391034
  3. Connect the hand brake cable equaliser (1) to the left rear hand brake cable.
  4. Connect the hand brake cable connector (2) to the right rear hand brake cable.
  5. Caution: Refer to Fastener Caution in the Preface section.


    2391033
  6. Install the hand brake cable bracket nut (1) and tighten to 10 N·m (89 lb in).
  7. Install the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .

  8. 2391032
  9. Install the hand brake cable bracket nut (1) and tighten to 10 N·m (89 lb in).

  10. 2391030
  11. Install the hand brake cable bracket bolt (1) and tighten to 10 N·m (89 lb in).

  12. 2391020
  13. Install the hand brake cable nut (1) to the electronic hand brake control module and tighten to 6 N·m (53 lb in).
  14. Install the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .
  15. Install the left rear tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .
  16. Enable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Enabling .
   


© Copyright Chevrolet. All rights reserved