To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Hand brake Rear Cable Replacement - Left Side

Removal Procedure
  1. Place the transmission in PARK.
  2. Disable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Disabling .
  3. Place the power button in the OFF position.

    4. Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

    5. 2376025
  5. Disconnect the left rear hand brake cable from the actuator lever (1) on the brake calliper.
  6. Compress the locking tabs on the left rear hand brake cable conduit (2) and remove the hand brake cable from the bracket.

    7. 2376026
  7. Release the left rear hand brake cable retainer (1) from the hydraulic brake pipe bracket.

    8. 2376027
  8. Release the hand brake cable retainer (1) from the vehicle underbody.
  9. Remove and position aside the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .

    10. 2391034
  10. Disconnect the hand brake cable equaliser (1) from the left rear hand brake cable.

    11. 2376029
  11. Remove the left rear hand brake cable (1) from the bracket on the vehicle underbody by compressing the locking tabs on the cable conduit.
  12. Remove the left rear hand brake cable from the vehicle.

Installation Procedure

    2376029
  1. Install the left rear hand brake cable (1) to the bracket on the vehicle underbody.
  2. Secure the locking tabs on the cable conduit to the hand brake cable bracket.

    3. 2391034
  3. Connect the hand brake cable equaliser (1) to the left rear hand brake cable.
  4. Install the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .

    5. 2376027
  5. Install the hand brake cable retainer (1) to the vehicle underbody.

    6. 2376026
  6. Install the hand brake cable retainer (1) to the hydraulic brake pipe bracket.

    7. 2376025
  7. Connect the left rear hand brake cable to the actuator lever (1) on the brake calliper.
  8. Secure the locking tabs on the left rear hand brake cable conduit (2) to the bracket.
  9. Enable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Enabling .
   


© Copyright Chevrolet. All rights reserved