To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Hand brake Rear Cable Replacement - Right Side

Removal Procedure

  1. Place the transmission in PARK.
  2. Disable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Disabling .
  3. Place the power button in the OFF position.
  4. Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

  6. 2376030
  7. Disconnect the right rear hand brake cable from the actuator lever (1) on the brake calliper.
  8. Compress the locking tabs on the right rear hand brake cable conduit (2) and remove the hand brake cable from the bracket.

  9. 2376031
  10. Release the right rear hand brake cable retainer (1) from the hydraulic brake pipe bracket.

  11. 2376032
  12. Release the right rear hand brake cable retainer (1) from the vehicle underbody.
  13. Remove and position aside the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .

  14. 2376034
  15. Disconnect the hand brake cable connector (1) from the rear hand brake cable.
  16. Remove the right rear hand brake cable (2) from the bracket on the vehicle underbody by compressing the locking tabs on the cable conduit.
  17. Remove the right rear hand brake cable from the vehicle.

Installation Procedure


    2376034
  1. Install the right rear hand brake cable to the bracket on the vehicle underbody.
  2. Connect the hand brake cable connector (1) to the rear hand brake cable.
  3. Secure the locking tabs on the cable conduit (2) to the hand brake cable bracket.
  4. Install the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .

  5. 2376032
  6. Install the right rear hand brake cable retainer (1) to the vehicle underbody.

  7. 2376031
  8. Install the right rear hand brake cable retainer (1) to the hydraulic brake pipe bracket.

  9. 2376030
  10. Install the right rear hand brake cable to the hand brake cable bracket on rear brake calliper.
  11. Connect the right rear hand brake cable to the actuator lever (1) on the brake calliper.
  12. Secure the locking tabs on the right rear hand brake cable conduit (2) to the bracket.
  13. Enable the hand brake cable adjuster. Refer to Hand brake Cable Adjuster Enabling .
   


© Copyright Chevrolet. All rights reserved