Volt

Draining Fluids and Oil Filter Removal

Special Tools

EN-726-A Oil Filter Spanner

For equivalent regional tools, refer to Special Tools .

1. Remove the oil sump drain plug (4) and the seal ring (1) allow the oil to drain out.
2. Remove the oil filter (2). Use EN-726-A wrench (3).

Caution: Refer to Fastener Caution in the Preface section.

3. Install the oil pan drain plug and a NEW seal ring and tighten to 14 N·m (124 lb in).



4. Remove the water pump drain plug (1) and the water pump drain plug seal ring (2) and allow the remaining coolant fluid to drain out.
5. Install the water pump drain plug and a NEW seal ring and tighten to 15 N·m (11 lb ft).