Volt

Inlet Manifold Assemble

1. Install a NEW inlet manifold gasket (1).
2. Install the manifold absolute pressure sensor (3).
3. Install the manifold absolute pressure sensor bolt (2) and tighten.



4. Install the fuel injector (2) to fuel rail.
5. Install the fuel injector retainer clamp (3).



6. Install the fuel rail (1).

Caution: Refer to Fastener Caution in the Preface section.

7. Install the 2 fuel rail bolts (2) and tighten to 7 N·m (62 lb in).



8. Install the evaporative emission canister purge solenoid valve (2) to the inlet manifold.
9. Install the evaporative emission canister purge solenoid valve bolt (1) and tighten.