To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Rear Side Door Window Belt Reveal Molding Replacement - Lower


2382123

Callout

Component Name

1

Rear Side Door Bright Molding

Procedure

  1. Apply several layers of masking tape to the bottom and top edge of the rear side door bright molding in order to protect the painted finish.
  2. Start at the lower rear edge of the bright lower molding. Use the tool in a twisting and lifting motion only.
  3. Working from rear of the molding to the rear of the door.
  4. Work the suitable tool (flat plastic) across the bottom edge of the molding releasing the clips from the molding.

2

Rear Side Door Bright Molding Clips (Qty: 8)

Procedure

  1. The clips are removed by turning them halfway or a hundred and eighty degrees) counter clockwise or until the clip release the outer door panel.
  2. Mark the location of the clips when removing.

3

Rear Side Door Bright Molding

  1. Install the clips to the bright molding if any of the clips are damage, it will be necessary to be replace them.
  2. Install the bright molding rubber seal to the molding after the clips have been reinstalled.
  3. Place the clips to the location in the outer door panel and push inward until fully seated.
   


© Copyright Chevrolet. All rights reserved