Volt

Rear Brake Hose Replacement

Warning: Refer to Brake Dust Warning in the Preface section.

Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .



3. Remove the rear brake pipe fitting (1) from the rear brake hose.
4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.



5. Remove the rear brake hose retainer (1).



6. Remove the rear brake hose bracket bolt (1).



7. Remove the brake hose fitting bolt (1).
8. Remove and discard the brake hose fitting gaskets (2) from the brake hose fitting (3).
9. Remove the rear brake hose.

1. Assemble the brake hose fitting bolt (1) and the new fitting gaskets (2) to the brake hose fitting (3).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the brake hose assembly to the brake calliper and tighten the fitting bolt to 40 N·m (30 lb ft).



3. Install the rear brake hose bracket bolt (1) and tighten to 9 N·m (80 lb in).



4. Install the rear brake hose retainer (1).



5. Install the rear brake pipe fitting (1) to the rear brake hose and tighten the fitting to 23 N·m (17 lb ft).
6. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding : Pressure .
7. Install the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .