To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Drive Motor Battery Charger Receptacle Replacement


2396972

Callout

Component Name

Preliminary Procedures

  1. Disable the high-voltage system. Refer to High Voltage Disabling .
  2. Remove the charge port housing. Refer to Charge Port Housing Replacement .

1

Drive Motor Battery Charger Receptacle Fastener (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
12 N·m (106 lb in)

2

Drive Motor Battery Charger Receptacle Fastener

Procedure

  1. Disconnect the electrical connector.
  2. Enable the high-voltage system. Refer to High-Voltage Enabling .
   


© Copyright Chevrolet. All rights reserved