To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transmission Fluid Cooler Pipe Connector Replacement - Radiator

For equivalent regional tools, Refer to Special Tools

Removal Procedure

  1. Place a drain pan under vehicle.
  2. Remove the transmission fluid cooler thermal bypass valve. Refer to Transmission Fluid Cooler Thermal Bypass Valve Replacement .

  3. 2398494
  4. Remove the oil cooler fitting (1) from the radiator.

Installation Procedure

  1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
  2. Caution: Refer to Fastener Caution in the Preface section.


    2398494

    Note: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.

  3. Install the oil cooler fitting (1) to the radiator and tighten to 38 N·m (28 lb ft).
  4. Install the transmission fluid cooler thermal bypass valve. Refer to Transmission Fluid Cooler Thermal Bypass Valve Replacement .
  5. Adjust the transmission fluid level.
  6. Inspect for fluid leaks.
   


© Copyright Chevrolet. All rights reserved