To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Mount Bracket Replacement - Right Side


2441539

Callout

Component Name

Preliminary Procedures

  1. Remove the engine mount. Refer to Engine Mount Replacement - Right Side .
  2. Remove the front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement .
  3. Remove the nuts retaining the drive motor battery to charge cable to the frame rail and reposition. Refer to 300-Volt Battery Positive and Negative Cable Replacement : Drive Motor Battery-to-APM Module → Drive Motor Battery-to-Charger → Inverter-to-Compressor/Heater Module → Drive Motor Battery-to-Inverter

1

Engine Mount Bracket Fastener (Qty: 2)

Caution: This component uses torque-to-yield bolts. When servicing this component do not reuse the bolts, New torque-to-yield bolts must be installed. Reusing used torque-to-yield bolts will not provide proper bolt torque and clamp load. Failure to install NEW torque-to-yield bolts may lead to engine damage.

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Raise and lower the engine as needed to access the bolts.
  2. Ensure to follow the tighten sequence.

Tighten

  1. First pass: 60 N·m (44 lb ft)
  2. Final pass: additional 45-60 degrees

2

Engine Mount Bracket Fastener

Procedure

Ensure to follow the tighten sequence.

Tighten

  1. First pass: 60 N·m (44 lb ft)
  2. Final pass: additional 45-60 degrees

3

Engine Mount Bracket

Procedure

Transfer components as necessary.

   


© Copyright Chevrolet. All rights reserved