To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Inlet Camshaft Replacement

Removal Procedure

  1. Remove the camshaft sprocket. Refer to Camshaft Inlet and Exhaust Sprocket Replacement .

  2. 2190728
  3. Remove the camshaft bearing cap bolts in sequence shown. Ensure to remove the bolts one turn at a time until there is no spring tension pushing on the camshaft.

  4. 2403116
  5. Remove the camshaft bearing cap bolts (1).
  6. Remove the camshaft bearing caps (2).
  7. Remove the inlet camshaft (3).

Installation Procedure


    2403116

    Note: Ensure that the camshaft sealing rings are in place in the camshaft grooves. Camshaft sealing rings must be in place below the surface of the camshaft journal in order to avoid being pinched between the cylinder head and the camshaft caps.

  1. Lubricate the camshaft and camshaft bearing caps with engine oil.
  2. Install the inlet camshaft (3).
  3. Install the camshaft bearing caps (2).
  4. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the camshaft bearing cap and hand tighten the bolts (1).

  6. 2190731
  7. Install and tighten the camshaft bearing cap bolts one turn at a time in sequence as shown to 8 N·m (71 lb in).
  8. Install the camshaft intake sprocket. Refer to Camshaft Inlet and Exhaust Sprocket Replacement .
   


© Copyright Chevrolet. All rights reserved