To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Crankshaft Balancer Replacement


2442279

Callout

Component Name

Preliminary Procedures

  1. Mark the balancer to the cover relationship or Set to TDC.
  2. Remove the water pump belt. Refer to Water Pump Belt Replacement .
  3. Remove the heater water auxiliary pump. Refer to Heater Water Auxiliary Pump Replacement
  4. Remove the drive motor battery coolant cooler Inlet hose assembly. Refer to Drive Motor Battery Coolant Cooler Inlet Hose Assembly Replacement

1

Crankshaft Pulley Fastener

Caution: Refer to Fastener Caution in the Preface section.

Tighten

    • 150 N·m (111 lb ft)
    • Tighten the bolt an additional 60 degrees.

2

Crankshaft Pulley

Procedure

  1. Use EN-49979 retainer and EN-956-1 extension to remove the crankshaft pulley.
  2. To ensure correct installation of the crankshaft pulley, measure the distance between the pulley and the front cover. Refer to Crankshaft Balancer Installation .

Special Tools

    • EN-470-B Angular Torque Wrench
    • EN-956-1 Extension
    • EN-49979 Crankshaft Shock Mount Retainer

For equivalent regional tools, refer to Special Tools .

   


&#169© Copyright Chevrolet. All rights reserved