To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Driver or Passenger Seat Cushion Outer Finish Panel Replacement


2395029

Callout

Component Name

Preliminary Procedure

  1. Remove the seat belt from the seat belt anchor. Refer to Driver or Passenger Seat Retractor Side Belt Replacement .
  2. Remove the driver or passenger seat adjuster vertical actuator handle. Refer to Driver or Passenger Seat Adjuster Vertical Actuator Handle Replacement .
  3. Remove the driver or passenger seat recliner handle. Refer to Driver or Passenger Seat Recliner Handle Replacement .

1

Driver or Passenger Seat Outer Adjuster Finish Cover Rear Fastener

Procedure

  1. Make sure the seat is in the full up position.
  2. After removal of the fastener, using a flat bladed tool, pry upward on the tab connecting the inner and outer panels..

2

Driver or Passenger Seat Outer Adjuster Finish Cover Side Fastener

Procedure

After removal of the fastener, using a flat bladed tool, pry upward on the two tabs connectng the inner and outer panels.

3

Driver or Passenger Seat Outer Adjuster Finish Cover Front Fastener

4

Driver or Passenger Seat Outer Adjuster Finish Cover

Procedure

  1. Push downward on the front hidden clip to release the panel from the frame.
  2. Pull upward on the finish trim top edge to release the panel ribs from the frame.
  3. Disconnect any electrical connector, if equipped.
  4. If replacing the cover, transfer components as necessary.
   


© Copyright Chevrolet. All rights reserved