To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Inflatable Restraint Sensing and Diagnostic Module Replacement


2409671

Callout

Component Name

Warning: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Warning: Refer to SIR Warning in the Preface section.

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the console. Refer to Front Floor Console Replacement .
  3. Disconnect the electrical connector.

1

Inflatable Restraint Sensing and Diagnostic Module Fastener (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
10 N·m (89 lb in)

2

Inflatable Restraint Diagnostic Energy Reserve Module Fastener Tape

Note: This foil tape should be installed on the top of the SDM module whenever you are installing a replacement SDM module that was equipped with foil tape.

3

Inflatable Restraint Sensing and Diagnostic Module Assembly

Note: 

   • When installing, ensure the arrow on the module is pointed towards the front of the vehicle.
   • If installing a replacement module, program the module. Refer to Control Module References .

   


&#169© Copyright Chevrolet. All rights reserved