Drive Motor Generator Control Module Coolant Pump Hose Replacement
Special Tools
BO-38185 Hose Clamp Pliers
For equivalent regional tools, Refer toSpecial Tools
Removal Procedure
Note: Replace corroded hose clamps and brackets.
- Remove the front wheelhouse front liner on the driver's side. Refer to Front Wheelhouse Front Liner Replacement
- Place a drain pan under pump.
- Remove the drive motor generator control module coolant pump hose clamp (1) at generator control module coolant pump using BO-38185 Hose Clamp Pliers .
- Remove the drive motor generator control module coolant pump hose (2) from the generator control module coolant pump.
- Remove the drive motor generator control module coolant pump hose clamp (1) at drive motor battery coolant air separator using BO-38185 Hose Clamp Pliers .
- Remove the drive motor generator control module coolant pump hose (2) from drive motor battery coolant air separator.
- Remove the drive motor generator control module coolant pump hose from the vehicle.
Installation Procedure
- Install the drive motor generator control module coolant pump hose to the vehicle.
- Install the drive motor generator control module coolant pump hose (2) to the drive motor battery coolant air separator.
- Install the drive motor generator control module coolant pump hose clamp (1) at drive motor battery coolant air separator using BO-38185 Hose Clamp Pliers .
- Install the drive motor generator control module coolant pump hose (2) to the generator control module coolant pump.
- Install the drive motor generator control module coolant pump hose clamp (1) at generator control module coolant pump using BO-38185 Hose Clamp Pliers .
- Install the front wheelhouse front liner on the driver's and passenger side. Refer to Front Wheelhouse Front Liner Replacement
- Remove the drain pan.
- Fill the cooling system.
© Copyright Chevrolet. All rights reserved |