Preliminary Procedures

1. Remove the front fascia. Refer to Front Bumper Fascia Removal and Installation : Volt → Ampera .
2. Remove the air inlet extension. Refer to Air Inlet Grille Panel Extension Replacement .
3. Remove the front wing upper rear moulding. Refer to Front Fender Upper Rear Moulding Replacement .
4. Remove the front compartment side sight shield. Refer to Front Compartment Side Sight Shield Replacement : Volt → Ampera .
5. Remove the front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement .
6. Remove the front wheelhouse rear liner. Refer to Front Wheelhouse Rear Liner Replacement .
7. Remove the sill panel moulding. Refer to Sill Panel Moulding Replacement .
8. Remove the right headlamp. Refer to Headlamp Replacement : Volt → Ampera .

1

Right Wing Bolt (Qty: 7)

Caution : Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

2

Front Wing

Procedure

Transfer parts as needed.