Volt

Rear Parking Assist Alarm Sensor Replacement

1. Remove rear bumper fascia. Refer to Rear Bumper Fascia Removal and Installation : Volt  → Ampera .
2. Disconnect electrical from the rear object sensor.
3. Lift the locking tabs on the housing and remove the rear object sensor.

Note: Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.

1. Paint the rear object sensor. Refer to Basecoat/Clearcoat Paint Systems .
2. Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gauges .



3. Insert the sensor into the housing.
4. Connect the electrical connector to the rear object sensor.
5. Install the rear bumper fascia. Refer to Rear Bumper Fascia Removal and Installation : Volt  → Ampera .