To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P0752

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0752: Shift Solenoid (SS) 1 Valve Performance - Stuck On

Circuit/System Description

The shift solenoid 1 and transmission control module (TCM) are part of the control solenoid valve assembly and are not serviced separately. The transmission control module supplies 12 V to shift solenoid 1 on the high side driver 1 circuit. The transmission control module controls the normally closed shift solenoid 1 on the shift solenoid 1 control circuit. The shift solenoid 1 controls the transmission fluid to the 1-3 clutch regulator valve assembly.

Conditions for Running the DTC

    • Any transmission shift without engine or engine transition to Off.
    • Line pressure is greater than 325 kPa.

Conditions for Setting the DTC

The transmission control module detects shift solenoid valve 1 is commanded OFF and TCM is unable to confirm transition.

Action Taken When the DTC Sets

P0752 is a Type A DTC.

Conditions for Clearing the DIC/DTC

P0752 is a Type A DTC.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

  1. Verify that P0966, P0967, P0969, P0970, P0971, P0973, P0974, P0976, P0977, P2720, P2721, P2728, P2729, or P2730 is not set.
  2. If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
  3. Perform the Transmission Fluid Level and Condition Check .
  4. Perform the Line Pressure Check .
  5. Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
  6. Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test .
  7. If the shift solenoid 1 is found to be leaking or stuck OFF, replace the Q8 control solenoid valve assembly.
    If the Q8 control solenoid valve assembly tests normal, inspect the valve body and hydraulic circuits for a leak or a stuck valve. Refer to Control Valve Body Diagnostic Inspection .

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    • Control Valve Body Replacement for control valve body replacement.
    •  Control Module References for Control Solenoid Valve Assembly and Transmission Control Module Assembly replacement, programming, and setup.
   


&#169© Copyright Chevrolet. All rights reserved