To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P2728-P2730

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P2728: Pressure Control Solenoid 5 System Performance

DTC P2729: Pressure Control Solenoid 5 Control Circuit Low Voltage

DTC P2730: Pressure Control Solenoid 5 Control Circuit High Voltage

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Clutch Pressure Control Solenoid 5 Control

P2729

P2730

P2730

P2728

Circuit/System Description

The clutch pressure control solenoid 5 is part of the control solenoid valve assembly and is not serviced separately. The transmission control module supplies 12 volts to the pressure control solenoid 5 through the high side driver 1 circuit. The transmission control module controls the pressure control solenoid 5 through the pressure control solenoid 5 control circuit. The normally low pressure control solenoid 5 directs fluid flow to the damper clutch when commanded ON and exhausts fluid when commanded OFF. The clutch pressure control solenoid 5 regulates to the damper clutch during auto start/stop transitions.

Conditions for Running the DTC

    • The propulsion system is active.
    • The system voltage is 11-16 V.

Conditions for Setting the DTC

P2728

The transmission control module detects an internal electrical performance malfunction of the clutch pressure control solenoid 5 control circuit for 5 seconds.

P2729

The transmission control module detects an internal low voltage electrical malfunction of the clutch pressure control solenoid 5 control circuit for 1 second.

P2730

The transmission control module detects an internal high voltage electrical malfunction of the clutch pressure control solenoid 5 control circuit for 1 second.

Action Taken When the DTC Sets

    • DTC P2728 is a Type B DTC.
    • DTCs P2729 and P2730 are Type A DTCs.

Conditions for Clearing the DTC

    • DTC P2728 is a Type B DTC.
    • DTCs P2729 and P2730 are Type A DTCs.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

  1. Vehicle ON, verify the transmission fluid temperature is between 50-80°C (122-176°F).
  2. Drive the vehicle, observe the scan tool Pressure Control Solenoid Valve 5 Performance Test Status parameters. The reading should display OK.
  3. If the reading is not within the specified range, replace the Q8 control solenoid valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for Control Solenoid Valve Assembly and Transmission Control Module Assembly replacement, programming, and setup.

   


&#169© Copyright Chevrolet. All rights reserved